برد کنترلر پرینترهای سه بعدی MKS Robin Nano STM32 همراه با نمایشگر رنگی و لمسی Robin TFT3.2

*** 1× MKS Robin Nano motherboard***
*** 1× 3.2 inch touch screen***
*** 1× 30cmFFC cable ***
*** 1× USB cable ***

*2*Product introduction
* The method of configuring the firmware is simple;
* The operation interface is simple;
* Firmware can be easily upgraded through the SDK and the user interface can be customized;
* Suitable for mass production of 3D printers for use as a main control board;

*3* Features advantages
* Using 32-bit high-speed ARM chip as the main control chip, using independent research and development firmware;
* With TFT touch screen (optional 2.4 inch, 2.8 inch, 3.2 inch), simple operation interface and high sensitivity;
* External WIFI module, access to the cloud, to achieve remote printing of the cloud model. And provide Android IOS system mobile app, support Chinese and English;
* With the shutdown module, you can complete the shutdown function;
* Flexible motor drive seat mode, can support 4988, 8825 and various in-line drives, and support external drivers to meet your various drive requirements;
* Upgrade firmware configuration through SD card, easy to operate;
* Boot logo and all buttons and other interfaces can be designed by yourself;
* Up to 15 custom button functions can be supported;
* Specialized in heat dissipation optimization;
* Use high quality MOSFET tube for better heat dissipation;
* Use dedicated power chip to support 12V-24V power input;
* Can accept 24V input, the same system power can reduce the hot bed current to 1/4, effectively solve the hot bed MOS tube heating problem;
* Support breakpoint continuous play function, power off save function, break detection function, after the shutdown function;

***Product parameters***
* Motherboard model: MKS Robin Nano
* Appearance size: 110*84 (mm)
* Hole size: 102*76 (mm)
* Microprocessor: STM32
* Input voltage: 12V~24V, 5A~15A
* Motor drive: 4988, 8825, 8729 and other drive and external drive
* Temperature sensor interface: NTC100K, 31855
* Support for print file format: G-code
* Support machine structure: XYZ/delta/kossed/Ultimaker/corexy
* Recommended software: Cura/Simplitfy3d/Pronterface/Prpetier-Host
* Firmware update: SD card update